BMW K bikes (Bricks)

You are not connected. Please login or register

View previous topic View next topic Go down  Message [Page 1 of 1]


1Back to top Go down   Engine noise on cold (again) Empty Engine noise on cold (again) on Tue Oct 18, 2016 2:38 pm

nino

avatar
Life time member
Life time member
Having same problem of excessive noise when engine was cold, today I tried to do something with alternator which together with clutch was usual suspect. I always thought that three hard metal to metal point of alternator to engine block resonate too much. I have new bearings in alternator but it didnt help.

Just for test I removed alternator and put three rubber nitrile washers resistant to heat (100 C) and push it back. After bolt tightening I started the cold engine.
Noise partialy dissapeared. Ok I heard the cluth but only with released lever. With engaged lever engine was quiet even on low cold rpms.

Did anyone tried this method? What is experience with rubber washer durability? I used 2 mm thick washer inside diameter 8 mm. When tighten probably squeeze to 1 mm between block and three contacts.
Best regards

    

2Back to top Go down   Engine noise on cold (again) Empty Re: Engine noise on cold (again) on Tue Oct 18, 2016 3:03 pm

charlie99

charlie99
VIP
VIP
good work nino


__________________________________________________
cheezy grin whilst riding, kinda bloke ....oh the joy !!!! ...... ( brick aviator )

'86 K100 RT..#0090401 ..."Gerty" ( Gertrude Von Clickandshift ) --------O%OEngine noise on cold (again) Au-log10

"redframe" rs "bitsa"  with many contributions from the k100 community ,,with many thanks
    

3Back to top Go down   Engine noise on cold (again) Empty Re: Engine noise on cold (again) on Tue Oct 18, 2016 10:49 pm

blaKey

blaKey
Life time member
Life time member
Yeah, good work!

Any chance of a photo?


__________________________________________________
Neil
K100RS 1986 RED!

Dress for the ride and the potential slide.
    

4Back to top Go down   Engine noise on cold (again) Empty Re: Engine noise on cold (again) on Wed Oct 19, 2016 7:12 am

nino

avatar
Life time member
Life time member
Its very simple. Three nitrile rubber washer between alternator and engine block on connecting points. Inside diameter of washer 8 mm. 


https://i.servimg.com/u/f97/17/38/82/76/washer10.jpg

    

5Back to top Go down   Engine noise on cold (again) Empty Re: Engine noise on cold (again) on Wed Oct 19, 2016 7:21 am

blaKey

blaKey
Life time member
Life time member
Thanks!


__________________________________________________
Neil
K100RS 1986 RED!

Dress for the ride and the potential slide.
    

6Back to top Go down   Engine noise on cold (again) Empty Re: Engine noise on cold (again) on Wed Oct 19, 2016 7:09 pm

Crazy Frog

Crazy Frog
admin
admin
Thanks Nino. This is a good tip.


__________________________________________________
Engine noise on cold (again) Frog15Engine noise on cold (again) Logo2101986 k75, 1985 K100rt, 1985 K100rt/EML GT2 sidecar, 1999 K1200lt/Hannigan Astro Sport sidecar.
    

7Back to top Go down   Engine noise on cold (again) Empty Re: Engine noise on cold (again) on Thu Oct 20, 2016 2:23 am

nino

avatar
Life time member
Life time member
What I can say after yesterday driving around office - caffe - office - lunch - office, mostly on semi cold engine? Old K with 180 000  was noticeable quieter. Few engine runs 4 - 5 - 6 rpm were were somehow more pleasant without usual buzzing.
If anyone try this simple mode, share experience, please.
Best regards

    

View previous topic View next topic Back to top  Message [Page 1 of 1]

Permissions in this forum:
You cannot reply to topics in this forum