BMW K bikes (Bricks)

You are not connected. Please login or register

View previous topic View next topic Go down  Message [Page 1 of 1]


Yeyo53

avatar
active member
active member
Hello, mates

Here I am again with a problem with the bep 3.0 and the acewell MA085.
Now the problem is that when I'm over 5000 rpms the needle start jumping. Under 5000 it works fine.

Any ideas? I just plugged the wire to the RPM hole in the bep.

Thanks in advance.

    

D'Ecosse

avatar
active member
active member
I can't speak for the MA085 but with the Acewell 2853 model, the RPM worked perfectly when the Black/Blue wire (from OEM Coil INTO the BEP3) was connected DIRECTLY to the RPM input of the Acewell (i.e. NOT going through the RPM conditioning circuit, but connected directly)
Try it and see how that works

    

View previous topic View next topic Back to top  Message [Page 1 of 1]

Permissions in this forum:
You cannot reply to topics in this forum