BMW K bikes (Bricks)

You are not connected. Please login or register

View previous topic View next topic Go down  Message [Page 1 of 1]


1Back to top Go down    Output shaft bearing on Thu Feb 20, 2014 6:27 pm

smoll1


Silver member
Silver member
Hi everyone

Just putting new bearings on output shaft have later bearing with the shoulder not clip, should I use little bit of bearing fix Loctite on bearing to stop it spinning in the case. I see the genuine manual says use some bearing fix but underneath it also says"do not bond ball bearing with shoulder at its outer race"??? any advice would be great????

Thanks

SmollVery HappyVery HappyVery HappyVery Happy

    

View previous topic View next topic Back to top  Message [Page 1 of 1]

Permissions in this forum:
You cannot reply to topics in this forum