BMW K bikes (Bricks)


You are not connected. Please login or register

View previous topic View next topic Go down  Message [Page 1 of 1]


The Chad

avatar
active member
active member
Hi. So I thought I had a fueling problem since my bike was cutting out after warming up a bit, and using a hair drier to heat the Hall sensor didn't affect the bike in deciding when it would shut off. But today, after disassembling all the electrical connections again to test them, I found that I had no continuity between Pin 2,3 and 4 from the Ignition Plug on the female side. (And no power from pin 2). I checked the wire for any cuts, but there is none. Can the male plug to the hall sensor go bad? It looks to be in good shape. What should I test next?

    

View previous topic View next topic Back to top  Message [Page 1 of 1]

Permissions in this forum:
You cannot reply to topics in this forum