BMW K bikes (Bricks)


You are not connected. Please login or register

View previous topic View next topic Go down  Message [Page 1 of 1]


Brad-Man

Brad-Man
Life time member
Life time member
Anyone dealt w/this before?

I used PB Blaster on it overnight when I saw it was taking more effort that the two truly visible allen head screws but to no avail.

Had a long proper-sized allen head bit in my ratchet and it just flat stripped it inside.

Verified by taking out the starter to see and get more room.

Anyone dealt w/this before?

Any solution other than dropping the engine/tranny to get it out w/bolt extractor on an impact wrench?

Any experiences shared would be appreciated.

TIA,

Brad

    

Rick G

Rick G
admin
admin
Get a 5/16in drill and drill the head of the bolt, remove the alternator and the stub will probably come out by hand.
A torx bit will often hammer into the hole and give you one more go.


__________________________________________________
"Man sacrifices his health in order to make money.
Then he sacrifices money to recuperate his health.
And then he is so anxious about the future that he does not enjoy the present; the result being that he does not live in the present or the future; he lives as if he is never going to die, and then dies having never really lived."   Dalai Lama


Bikes 1999 K1100 LT with a Big Block 1200
    

duck

duck
Life time member
Life time member
That's one of the bolts where there always ends up being a fair amount of corrosion in the threads. That, and the fact that the last time it was turned was probably when it was torqued on the assembly line.

Because of this, I usually remove the coils and use the really good 6mm Allen wrench from the factory toolkit with a piece of "persuader" pipe on the end.

PB blaster isn't that great for stuff like this.  Usually heating the bolt up with a small torch works better on stubborn bolts.

I agree on drilling the head off. If the stub doesn't come out by hand then crank down on it with some Vise-Grips to break it free.

You might want to consider putting anti-seize on the threads when re-installing.  I always do.


__________________________________________________
Current stable:
86 Custom K100 (standard fairing, K75 Belly pan, Ceramic chromed engine covers, paralever)
K75 Frankenbrick (Paralever, K11 front end, hybrid ABS, K1100RS fairing, radial tires)
86 K75C Turbo w/ paralever
94 K1100RS
93 K1100LT
91 K1
93 K75S (K11 front end)
91 K75S (K1 front end)
14 Yamaha WR250R
98 Taxi Cab K1200RS
14 K1600GT
http://www.ClassicKBikes.com
    

Brad-Man

Brad-Man
Life time member
Life time member
I'll break out my mini-torch and heat it up, then try using my easy-outs first -if I can figure a way to keep pressure on it while turning w/a breaker bar...

I always use anti-seize when I put bolts into aluminum.  Goes along w/being anal...

Thanks guys.  If I can't get it w/the rear wheel/tire and front part of the fender on the bike will remove them to get at it - don't have a right angle drill.

Will be a good opportunity to pull the tranny back and lube the clutch splines...

Of course, I also have a 4V engine & tranny that I could put in...but I don't want to do that until I'm ready to Micro-Squirt it...

    

View previous topic View next topic Back to top  Message [Page 1 of 1]

Permissions in this forum:
You cannot reply to topics in this forum