BMW K bikes (Bricks)


You are not connected. Please login or register

View previous topic View next topic Go down  Message [Page 1 of 1]


1Back to top Go down   Fuse box Empty Fuse box Sat Dec 27, 2014 1:51 pm

andy1141

andy1141
New member
New member
Hello
K100rt I wanted to know do you have to remove the tank to get inside fuse and relay box.
Someone has wired up the fourth fuse holder which I believe is spare and it keeps blowing fuses so I wanted to trace where it went.
I know fuel gauge dosnt work I've looked in tank and its corroded. Also I don't think the smaller aux sockets don't work either 
There is also a small switch just above dash board light I havent a clue what's that for .
Any ideas thanks andy

    

2Back to top Go down   Fuse box Empty Re: Fuse box Sat Dec 27, 2014 2:55 pm

Inge K.

Inge K.
VIP
VIP
To just change a relay it's enough to lift the tank in the rear end, but you get far
better acces if you remove the tank.

Fuse #4 is for the aux. power socket (if mounted,.....on top of the coil cover,
and/or the crashpad underneath the instruments).


__________________________________________________
Inge K.
K100RS -86. (first owner), K1100LTSE -94.
    

3Back to top Go down   Fuse box Empty Re: Fuse box Sat Dec 27, 2014 3:54 pm

andy1141

andy1141
New member
New member
Thanks for that .
I thought you did. It's not effecting anything else so I will look at wiring when I atempt the the fuel gauge .
Andy

    

Sponsored content


    

View previous topic View next topic Back to top  Message [Page 1 of 1]

Permissions in this forum:
You cannot reply to topics in this forum