Message [Page 1 of 1]
2
Re: So that was the noise! Sun Feb 02, 2020 3:09 am
GF Wollongong
Platinum member
The pic is my mates R65 sent through today
I had been on his case to get it going. We went for ride - it was going fine for about 2 hours and he was on his way back to Sydney from Wollongong. Approaching Bulli... loud noise ... side of the road and up into the ute.
Not all bad ... he's now thinking of upgrading to 900cc - assumes it will be about the same price.
He has been unable to get the valve out of the piston and told him to get it framed and onto the wall ... Burt Munro style ("sacrifices to the god of speed")
GF
I had been on his case to get it going. We went for ride - it was going fine for about 2 hours and he was on his way back to Sydney from Wollongong. Approaching Bulli... loud noise ... side of the road and up into the ute.
Not all bad ... he's now thinking of upgrading to 900cc - assumes it will be about the same price.
He has been unable to get the valve out of the piston and told him to get it framed and onto the wall ... Burt Munro style ("sacrifices to the god of speed")
GF
3 Re: So that was the noise! Sun Feb 02, 2020 5:27 am
Dai
Life time member
I've smacked a few valves against pistons and left a trench or two behind, but never done that!
__________________________________________________
1983 K100 naked upgraded to K100LT spec after spending time as an RS and an RT
1987 K100RT
Others...
1978 Moto Guzzi 850-T3, 1979 Moto Guzzi 850-T3 California,1993 Moto Guzzi 1100ie California
2020 Royal Enfield Bullet 500
Message [Page 1 of 1]
Similar topics
Permissions in this forum:
You cannot reply to topics in this forum
|
|
|
