1
fan motors reacting differently to temp sensor Sun Mar 01, 2020 7:53 am
88
Life time member
In preparation for Kedada Alicante I had to swap Rads. MY K11LT one had developed a hole in the matrix. Luckily I had one complete with working fan from the K1100rs already out on the shelf.
After swapping Rads complete with fan the Newly installed one does not kick in any where near as early as the previous unit. It doesn't cut in until temp is in the high red. The previous unit cut in almost too early at the halfway mark. (Same gauge)
Am I missing a trick?
After swapping Rads complete with fan the Newly installed one does not kick in any where near as early as the previous unit. It doesn't cut in until temp is in the high red. The previous unit cut in almost too early at the halfway mark. (Same gauge)
Am I missing a trick?
__________________________________________________
88....May contain nuts!"The world is a book and those who do not travel read only one page." - St. Augustine from 1600 years ago & still true!
K1100LT 1992 - AKA Big Red
K1100RS - 1995. AKA Rudolf Von Schmurf (in a million bits)
K1/RS - AKA Titan (unique hybrid by Andreas Esterhammer)
If the connector of the replacement fan was clean and in good shape when connected, the simplest course for me would be to remove the thermostat to verify that it's opening at the correct temperature.
